The 1+1 hot backup functional board supported by the ZXCTN 6300/6200 equipment include

A. The working ambient temperature of the ZXMP M600 is 0~45oC/32~113oF. The humidity is 10%~90% (35oC).

B.The 1U equipment supports two installation modes: installation on the 19” standard rack (ETSI compatible) and desktop installation. The 6U equipment supports the installation on the 19” standard rack.

C.All optical interfaces on the ZXMP 600 are SC connectors.

D.The 6U CWE cabinet supports the -48V/-60V (1+1 hot backup and dual input) power input.

A、1+N backup

B、Facility backup

C、1+1 backup

D、one to one backup

ite must be available if the entire data center site should become unavailable. To reduce costs, this backup site does not need to be up and running at all times ready for failover. It must contain equipment and the ability to restore data from the data center.Which of the following site types should be considered to meet these requirements？（）

A. Hot site

B. Warm site

C. Cold site

D. Active failover site

A.Init

B.Idle

C.Active

D.Standby

E.Established

F.Backup

A.Standby

B.Established

C.Active

D.Idle

E.Backup

F.Init

A.root

B.designated

C.alternate

D.backup

E.forwarding

F.learning

er1. After the mksysb is mounted in /mnt/backup/ from the local nim server.Which command should be run to restore the file？（）

A.tar -xvf /mnt/backup/server1.mksysb ./etc/resolv.conf

B.restore -Tvf /mnt/backup/server1.mksysb ./etc/resolv.conf

C.listvgbackup -f /mnt/backup/server1.mksysb -r ./etc/resolv.conf

D.restorevgfiles -xrm /mnt/backup/server1.mksysb ./etc/resolv.conf

A.shutdown

B.disable

C.backup

D.Listening

E.alternate

F.Blocking

ata on the servers in your network by using NTBackup. Your manager instructs you to document the procedure for restoring aserver from a backup of the System State data.You need to select the correct method for performing a restoration of a backup of the System State data.What should you do？（）

A. Run the following command: ntbackup.exe backup /F {"FileName"}

B. Run the following command: ntbackup.exe backup systemstate /F {"FileName"}

C. In Control Panel, open System, and configure the Startup and Recovery settings on the Advanced tab.

D. Use NTBackup interactively.

stem State data on the servers in your network by using NTBackup. Your manager instructs you to document the procedure for restoring a server from a backup of the System State data.You need to select the correct method for performing a restoration of a backup of the System State data.What should you do？（）

A. Run the following command: ntbackup.exe backup /F {"FileName"}

B. Run the following command: ntbackup.exe backup systemstate /F {"FileName"}

C. In Control Panel, open System, and configure the Startup and Recovery settings on the Advanced tab.

D. Use NTBackup interactively.