Fault management is the most critical in T-MPLS OAM function, and its alarm managemen

A.Fault Management(FM)

B.Configuration(CM)

C.Security Management(SM)

D.Performance Management(PM)

It’s management that is at fault （) the work-force.

A.would rather

B.rather too

C.rather than

D.had rather

A. load balancing

B. scalability

C. remote management

D. fault tolerance

E. service assurance

A.ncontinuity check

B.nloopback

C.nAlarm indication signal

D.nremote defect indicatio

E. nlock

F.F. TST

A.RSS configuration and fault management (CFM)

B.Layer 1 interface

C.Layer 2 interface

D.Layer 3 information

E.RSS A-bis interface

F.F.Handover detection and power control (HDPC)

A.Allows the management server to communicate with the controllers

B.Allows the issuing of text commands to manage the EVA

C.Allows scripts for remote replication tools to be used

D.Allows fault reporting to a remote location

ance Agent contained in Cisco IOS. Which CiscoWorks network management application will be used to report the latency and availability for configured traffic operations on an end-to-end and hop-byhop (router-to router) basis？（）

A. nGenius Real-Time Monitor

B. Cisco View

C. Device Fault Manager

D. Internetwork Performance Monitor

, performance monitoring or protection changeover.If a CV/CC frame. received by MEP has a MEL lower than the one of the destination MEP and a different MEG ID, the alarm generated should be().

A.Mismerge

B.Unexpected MEL

C.Unexpected MEP

D.Loss of continuity (LOC)

管理员开启虚拟SAN集群的高可用性（HA)。 以下有四个vmkernel端口组分配了下面的IP地址 - Manage

ment: 192.168.12.10 - vMotion: 192.168.13.10 - Virtual SAN: 192.168.14.10 - Fault TolerancE.192.168.15.10 HA将使用哪个IP地址来traffic？

ctions as a file server.The data volume on the server is configured as a software RAID-5 array. One of disks that contain the data volume fails. You replace the failed disk. You start the Disk Management utility and view the status listed in the following table.You need to restore fault tolerance.Which two actions should you perform？（） (Each correct answer presents part of thesolution. Choose two.)

A. Create a striped set that includes Disk1 and Disk2.

B. Initialize Disk3 and convert it to a dynamic disk.

C. Reactivate the RAID-5 array volume.

D. Repair the RAID-5 array volume to include Disk3.

E. Initiailize Disk3 and configure it as a basic disk.

F. Reactivate the missing disk.