当前位置: 首页 > 问题分类 > 计算机类考试 > 思科认证 > 问题详情
问题

You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)

A. Switch(vlan) mode trunk

B. Switch(config) switchport access mode trunk

C. Switch(config-if) switchport mode trunk

D. Switch(config-if) switchport trunk encapsulation dot1q

E. Switch(config) switchport access mode 1

F. Switch(vlan) trunk encapsulation dot1q

参考答案
正确答案:CD
C,D 解析:Explanation:
Creating this trunk link is a two step process. First you have to set the switchport mode to trunk, and then you configure the encapsulation. The giveaway on this question is the fact that to create a trunk on an interface, you have to be in interface configuration mode. So switchport mode trunk sets the trunk, and switchport trunk encapsulation dot1q sets the encapsulation.
您可能感兴趣的试题
  • How can a Ezonexam administrator determine if a router has been configured when it is first powered up?

    A.A configured router prompts for a password

    B.A configured router goes to the privileged mode prompt

    C.An un configured router goes into the setup dialog

    D.An un configured router goes to the enable mode prompt

  • FTP工作在OSI哪一层()

    A.会话层

    B.表示层

    C.传输层

    D.应用层

  • An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.

    What does 'line protocol is up' specifically indicate about the interface?

    A.The cable is attached properly.

    B.CDP has discovered the connected device.

    C.Keepalives are being received on the interface.

    D.A carrier detect signal has been received from the connected device.

    E.IP is correctly configured on the interface.

  • 交换机工作在OSI七层模型的哪一层()

    A.物理层

    B.数据链路层

    C.网络层

    D.传输层

×
验证