CDP is being used throughout the Ezonexam network. What are two reasons why the Ezonexam n

r of a new ISP. A full T1 is being used for the Internet connection. After issuing the show interface serial 0/0 command, it is observed that the interface is UP and the line protocol is DOWN.Which of the following commands could fix this problem？（）

A. Border# copy running-config startup-config

B. Border(config)# no shutdown

C. Border(config-if)# encapsulation ppp

D. Border(config-if)# no cdp enable

E. Border(config-if)# ip routing

58 Which of the following terms refers to the situation where the work is being used for the purpose intended and so certified:

A. beneficial completion

B. substantial completion

C. project completion

D. contract closeout

E. final completion

A.RIP

B.STP

C.IGRP

D.CDP

E.VTP

A.ARP

B.CDP

C.DHCP

D.DNS

E.ICMP

A.IGRP

B. CDP

C. OSPF

D. RIP v1

E. RIP v2

F. EIGRP

A.ARP

B.CDP

C.DHCP

D.DNS

E.ICMP

n a loop-free network？

A. RIP

B. STP

C. IGRP

D. CDP

E. VTP

F. None of the above

A. It is globally enabled by default on Cisco routers.

B. It is globally enabled by default on all routers.

C. It is a proprietary protocol.

D. It is a non-proprietary protocol.

E. It can be used to gather hardware and protocol information about neighbor devices.

strator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F？（）

A. Issue the show ip route command on Router A

B. Issue the show ip route command on Router B

C. Issue the show cdp neighbors command on Router B

D. Issue the show cdp neighbors detail command on Router C

E. Issue the show arp command on Router A

F. Issue the show arp command on Router B