题目
A. Redistribute connected interfaces on router B and router C
B. Set the maximum nu mber of equal cost paths to1 in all routers
C. When redistributing EIGRP into OSPF, set the external metric type to type E1
D. Adjust the default metrics in router B and router C so that the values are different in each router
E. None of these solut ions will fix the problem. Migrate to a single dynamic routing protocol
第1题
B.shouldshutdown.
C.shouldcontinueoperatingtemporarilydespiteaneconomiclossbecausethefirmisabletocoverallofitsvariablecosts.
D.shouldcontinueoperatingtemporarilydespiteaneconomiclossbecausethefirmisabletocoveraportionofitsfixedcosts.
E.shouldcontinueoperatingbecausethefirmismakingaprofit.
第3题
第4题
A.A level 5 password is not set
B.The vty password is missing
C.The console password is missing
D.An ACL is blocking Telnet access
第5题
A.3MB
B.4MB
C.5MB
D.7MB
E.8MB
第6题
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
第7题
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
第8题
Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router) network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? ()
A.FastEthernet0 /0
B.FastEthernet0 /1
C.Serial0/0
D.Serial0/1.102
E.Serial0/1.103
F.Serial0/1.104
第9题
A.The design will function as intended
B.Spanning-tree will need to be used.
C.The router will not accept the addressing scheme.
D.The connection between switches should be a trunk.
E.The router interfaces must be encapsulated with the 802.1Q protocol.
第10题
A. 24.9%, 980
B. 6.94%, 980
C. 69.4%, 35
D. cannot be determined from this output
E. 69.4%, 4061
第11题
A. CGMP version 2 is being used.
B. The switch will use sparse mode first, dense mode second.
C. A rendezvous point must be configured in order for the interface to operate in sparse mode.
D. IGMP version 2 is being used.
E. The rendezvous point is IP address 172.16.4.16.
F. If a rendezvous point is configured, the interface cannot operate in dense mode.
为了保护您的账号安全,请在“赏学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!