题目
A、Switch#enable
B、Switch#config terminal
C、Switch(config)#interface fastethernet 0/1
D、Switch#line console 0
第1题
在一台Cisco Catalyst 2950交换机上作如下配置:
Switch # config terminal
Switch (config) # interface fastethernet 0/1
Switch (config-if) # switchport mode access
Switch (config-if) # switchport access vlan2
若要将fastethernet 0/1端口还原到默认配置状态,可以使用()命令。
A、Switch (config) # default fastethernet 0/1
B、Switch (config) # default interface fastethernet 0/1
C、Switch (config) # no fastethernet 0/1
D、Switch (config) # erase interface fastethernet 0/1
第2题
A.ISL和set 3/1 trunk on isl
B.ISL和set trunk 3/1 on isl
C.IEEE 802.1Q和set tramk 3/1 on dotlq
D.IEEE 802.1Q和set 3/1 trunk on dotlq
第3题
A、Switch(config-if)#switchport mode access
B、Switch(config-if)#switchport dynamic auto
C、Switch(config-if)#switchport mode trunk
D、Switch(config-if)#switchport mode dynamic
第4题
Capability codes:R-Router, T-Trans Bridge, B-Source Route Bridge
S-Switch, H-Host, I-IGMP,r-Repeater, P-Phone
Device ID Local Intrfce Holdtme Capability Platform. Port ID
R1 Fas 0/19 135 R S I Cisco 2621 Fas 0/0
A、本地设备主机名称为R1
B、本地设备的F0/19端口与相邻设备的F0/0端口相连
C、相邻设备的主机名称为Cisco 2621
D、相邻设备是一台Cisco 2621路由器
第5题
A ) ISL 和 set 3/1 trunk on isl
B ) ISL 和 set trunk 3/1 on isl
C ) IEEE802.1Q 和 set trunk 3/1 on dotlq
D ) IEEE802.1Q 和 set 3/1 trunk on dotlq
第6题
A、switc# config
B、switc# config nvram
C、switc# copy running-config startup-config
D、switc# copy startup-config running-config
第7题
A、Show interface
B、Show cdp neighbors
C、Show running-config
D、Show mac-table
第8题
A.Duplex half
B.Duplex full
C.Speed 10
D.Speed100
第9题
A、cisco
B、ciscolab
C、enable
D、secret
第10题
A.show run?
B.show startup-config
C.show running-config
D.show run
E.show start
为了保护您的账号安全,请在“赏学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!