题目
Active Directory Service
The object VE32 could not be created.
The problem encountered was:
The directory service has exhausted the pool of relative identifiers.
You need to resolve the problem before continuing the installation.
What should you do?
A.Restart the domain's Global Catalog server.
B.Restart the domain's RID master server.
C.Restart the domain's PDC Emulator server.
D.Restart the domain's Infrastructure Master.
第1题
To do this, you enter the following command:
Ezonexam(config)# ip nat inside source static 192.168.2.1
198.18.1.254
You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank.
What is the most likely cause of the problem?
A.The keyword overload is missing from the command.
B.The NAT pool must be defined first.
C.An access list must be defined to create static NAT translations.
D.The interfaces must be configured for NAT.
E.None of the above
第2题
The corporate head office of Ezonexam has a teleconferencing system that uses VOIP (voice over IP) technology. This system uses UDP as the transport for the data transmissions. If these UDP datagrams arrive at their destination out of sequence, what will happen?
A.UDP will send an ICMP Information Request to the source host.
B.UDP will pass the information in the datagrams up to the next OSI layer in the order that they arrive.
C.UDP will drop the datagrams.
D.UDP will use the sequence numbers in the datagram headers to reassemble the data in the correct order.
E.UDP will not acknowledge the datagrams and wait for a retransmission of the datagrams.
第3题
A. 14
B. 15
C. 16
D. 30
E. 31
F. 32
第4题
A.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
B.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link
C.Full-duplex Ethernet can provide higher throughout than can half-duplex Ethernet of the same bandwidth
D.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex ethernet uses a jam signal
E.None of the above
第5题
A.Switch(config)# switchport trunk encapsulation isl
B.Switch(config)# switchport trunk encapsulation ietf
C.Switch(config-if)# switchport trunk encapsulation isl
D.Switch(config-if)# switchport trunk encapsulation ietf
E.Switch(config-if)# switchport trunk encapsulation dot1q
第6题
A.ROM, TFTP server, Flash
B.Flash, TFTP server, ROM
C.Flash, NVRAM, TFTP server
D.Flash, ROM, TFTP server
E.Flash, TFTP server, RAM
第7题
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex provides a point-to-point link
B.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth
D.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal
E.None of the above
第8题
You work as one of ten network administrators at theBostonoffice of Ezonexam.com.
The Ezonexam.com network includes Windows 2000 Professional client computer, Windows NT Workstation 4.0 client computers, Windows 98 client computers, and UNIX client computers. Ezonexam employees who use the Windows operating systems stores files on a shared folders on a Windows 2000 Server computer that is named EzonexamFileServerA.
You are now required to make the shared folders on EzonexamFileServerA available for the Ezonexam staff that uses UNIX computers.
What action should you take?
A.Install and configure NFS (Network File System) on EzonexamFileServerA.
B.Configure data volumes on EzonexamFileServerA to be FAT volumes.
C.Disable Server Message Block (SMB) signing on EzonexamFileServerA.
D.Install Simple TCP/IP Services on EzonexamFileServerA.
第9题
A. Duplex mismatch
B. A routing loop
C. Trunking mode mismatch
D. Improperly configured root bridge
E. Improperly configured static VLAN
F. None of the above
第10题
A.Configure port Fa0/1 to accept connections only from the static IP address of the server
B.Configure the MAC address of the server as a static entry associated with port Fa0/1
C.Employ a proprietary connector type on Fa0/1 that is incomputable with other host connectors
D.Configure port security on Fa0/1 to reject traffic with a source MAC address other than that of the server
E.Bind the IP address of the server to its MAC address on the switch to prevent other hosts from spoofing the server IP address
为了保护您的账号安全,请在“赏学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!