当前位置: 首页 > 问题分类 > 计算机类考试 > 思科认证 > 问题详情
问题

Which of the following statements correctly describe the differences between half-duplex and full-duplex Ethernet? (Select two answer choices.)

A.Full-duplex Ethernet uses CSMA/CD to prevent collisions.

B.Half-duplex Ethernet uses a loopback circuit to detect collisions.

C.A full-duplex Ethernet card allows 20Mbps for data transmission.

D.Full-duplex Ethernet makes use of two pairs of wires for data.

E.An Ethernet hub can operate both half and full duplex simultaneously.

参考答案
正确答案:BD
解析:Explanation:
Half-duplex Ethernet send and receives on the same line, so a loopback needs to be set to detect collisions. Alternatively, full-duple Ethernet doesn't have to because it uses two pairs of wire, one to send and the other to receive. Collisions are not possible on full duplex Ethernet networks.

Incorrect Answers:
A. Full duplex uses both pairs of wires, so transmissions are sent on the first pair, and data that is received come in on the other pair. This prevents collisions.

C. Full duplex allows for data to be sent and received at the same time. It will not double the amount of bandwidth at any given time. The speed of the Ethernet link will remain at 10/100.

E. Hubs are shared devices and can only support one mode, unlike switches.
您可能感兴趣的试题
  • Which type of cable should be used to make a connection between the Fa0/0 port on a router and the Fa0/0 port switch?

    A.Rollover cable

    B.Console cable

    C.Crossover cable

    D.Straight-through cable

    E.Serial cable

  • The IP network 210.106.14.0 is subnetted using a /24 mask. How many usable networks and host addresses can be obtained from this?

    A.1 network with 254 hosts

    B.4 networks with 128 hosts

    C.2 networks with 24 hosts

    D.6 networks with 64 hosts

    E.8 networks with 36 hosts

  • You have a class C network, and you need to design it for 5 usable subnets with each subnet handling a minimum of 18 hosts each. Which of the following network masks should you use?

    A.225.225.224.0.

    B.225.225.240.0.

    C.225.225.255.0.

    D.255.255.255.224

    E.225.225.255.240

  • You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?

    A.VE1(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1

    B.VE1(config)# ip default-route 10.1.1.0

    C.VE1(config)# ip default-gateway 10.1.1.0

    D.VE1(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1

×
验证