Router R1 learns two routes with BGP for prefix 200.1.0.0/16. Comparing the two routes, ro

to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP table on R2 for this route？（）

A. 22

B. 11

C. 1

D. None

terfaces. R1 learns a route from R2 using EIGRP f or IPv6. That route lists F0/0 as the outgoing interface with R2 as the next hop. The configuration excerpt shows all relevant configuration on R2‘s F0/0 interface. Which of the following is true about R1‘s route？（）interface f0/0mac - address 1111.1111.1 111ipv6 address 2000::/64 eui - 64ipv6 address 2001::1/64

A. The next hop is 2000::1311:11FF:FE11:1111

B. The next hop is FE80::1311:11FF:FE11:1111

C. The next hop is FE80::5111:11FF:FE11:1111

D. The next hop is 2001::1

reach the same destination via 6 different paths. All paths have the same metric and administrative distance.With all routers using the default operation,which of the paths will be chosen to reach the destination？（）

A. Only the first two paths that are learned.

B. Four of the paths.

C. All six routes in a routed robin fashion.

D. The oldest two paths in the routing table.

E. The first path learned to the destination network.

o parallel serial links between the two rou ters. The implementation plan calls for each router to base their BGP TCP connection on their respective loopback1 interfaces, with IP addresses 1.1.1.1 and 2.2.2.2, respectively.Which of the following commands would not be part of a working eBGP confi guration on Router R1？（）

A. router bgp 1

B. neighbor 2.2.2.2 remote- as 2

C. neighbor 2.2.2.2 update - source loopback1

D. neighbor 2.2.2.2 multihop 2

A.Receive - only

B. Stub

C. Static

D. Summary

E. Connected

F. Dynamic

erial link b etween the two routers uses IP addresses 10.1.1.1 and 10.1.1.2, respectively. Both routers use their S0/0 interfaces for this link.Which of the following commands would be needed on R1 to configure eBGP？（）

A. router bgp 2

B. router bgp 1

C. neighbor 10.1 .1.2 remote - as 2

D. neighbor 10.1.1.2 Update - source 10.1.1.1

E. neighbor 10.1.1.2 Update- source S0/0

A.Host 1 addresses the frames to the MAC address of router R1

B.Host 1 looks in its ARP cache for the MAC address of router R1

C.Host 1 addresses the frames to the MAC address of web server 2

D.Host 1 sends the packets to router R1 to be forwarded to web server 2

E.Host 1 sends a broadcast ARP request to obtain the MAC address of webserver2

o another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.Which of the following is most likely to be useful on the branch router？（）

A. IPsec tunnel

B. GRE tunnel

C. Floating stati c route

D. An IGP

e rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1‘s interface S0/0？（）

A. FEA0::200:FF:FE11:0

B. FE80::200:FF:FE11:1111

C. FE80::0213:19FF:FE7B:0:1

D. FEB0::211:11FF:FE11: 1111

our other working OSPF routers in that subnet. R1 is neither the designated router (DR) nor backup DR (BDR). OSPF is working correctly on all five routers.Which of the following is true on R1？（）

A. The show ip ospf neighbors command lists two neighbors off Fa0/0.

B. The show ip ospf neighbors command lists four neighbors off Fa0/0.

C. The show ip ospf neighbors command lists two neighbors off Fa0/0 in the FULL state.

D. The show ip ospf neighbors command lists two neighbors off Fa0/0 in the DISCO state.